Advice and tips
- WHAT DO I NEED TO KNOW BEFORE BUYING A FIREPLACE STOVE OR FIREPLACE INSERT?
- USE AND OPERATION OF FIREPLACE STOVES AND INSERTS
- TIPS FOR HEATING
- TIPS FOR HEATING
- How to use the fireplace stove or insert economically and ecologically?
- When I open the door of the fireplace stove (insert), smoke enters the room. How can I prevent this?
- Wood and its quality?
- Combustion air and its function?
- The glazing of the fireplace stove has cracked. What could have caused this?
- The chamotte lining in the fireplace stove (insert) has cracked. Does it need to be replaced.
- CHIMNEY TIPS
- CLEANING AND MAINTENANCE TIPS
- General rules for the maintenance of Romotop products
- How often should ashes be removed?
- How often do I need to clean a fireplace stove or insert?
- How frequently should I clean the hot-water exchanger?
- How often should the chamotte lining or individual chamotte tiles be replaced?
- The glass in the fireplace stove is covered in soot. What could be causing this?
- How can I clean the glass?
- Surface maintenance (accessories)
- Lubrication of friction areas and moving parts
- WHERE CAN I BUY SPARE PARTS FOR ROMOTOP FIREPLACE STOVES AND INSERTS?
- WHAT TYPES OF ENCLOSURES ARE AVAILABLE FOR FIREPLACE INSERTS?
- WHO CAN I CONTACT IN CASE OF A WARRANTY CLAIM OR FOR SERVICE SUPPORT?
TIPS FOR HEATING
When using the fireplace stove or insert for the first time, follow the instructions and rules in the installation and operating manual.
On first heating, the paint is hardened/fired, which is accompanied by a temporary smell that will later disappear, see also Glossary.
To start a fire, you will need a firelighter or paper, dry kindling and wood chopped into smaller and larger pieces.
Before you start, fully open the primary and secondary air intake.
Place the larger pieces of wood in the chamber, followed by the smaller pieces of wood, firelighter and finally the kindling.
Light the paper or firelighter. This way of starting a fire will ensure optimum heating of the system, reduce the amount of smoke, save fuel and ensure the glass stays clean.
Stoking: The most important thing is to use dry wood only.
Stoking is only necessary when there are only glowing embers and no flames in the stove or insert. Fully open the air intake. Leave the door partially open for a few seconds and only then open it fully. Place 2 to 3 logs on the glowing layer. Close the door.
Set primary air intake to ensure optimum combustion, so the wood burns with a clear flame, without excessive smoke. Leave the secondary air intake open for the duration of heating, regulate the amount to adjust the burning intensity. Secondary air is also used to clean the glass.